Dear friends, my WRF configuration includes 39 vertical layers specific as eta_1evels from 1.0000 to 0.0000, covering heights ranging from 7.93 to 18161.21 meters. I am particularly interested in the first 10 layers, focusing on near surface phenomena, therefore my MCIP’s CTMLAYS are set from 1.000 to 0.9649, plus 0.400, 0.200, and 0.000. However, after processing through Megan for SMOKE input, the output file only displays data in layers 0, 1, and 2. The top layer in SMOKE output corresponds to around. 42 meters, but some point sources in my input file are located at 100 meters, yet SMOKE does not include these higher data points.
eta_1evels=1.0000, 0.9979, 0.9956, 0.9931,
0.9904, 0.9875, 0.9844, 0.9807,
0.9763, 0.9711, 0.9649, 0.9575,
0.9488, 0.9385, 0.9263, 0.9120,
0.8951, 0.8753, 0.8521, 0.8251,
0.7937, 0.7597, 0.7229, 0.6833,
0.6410, 0.5960, 0.5484, 0.4985,
0.4467, 0.3934, 0.3393, 0.2850,
0.2316, 0.1801, 0.1324, 0.0903,
0.0542, 0.0241, 0.0000,
their corresponding heights are [7.93364096 24.58369827 42.80170822 62.59374237 83.96810913 106.9345855 133.04396057 164.25161743 201.38670349 245.69186401 298.84060669 362.17138672437.4945373527.52722168 634.74530029 762.66064453 915.50915527 1097.997558589 1315.87548828 1576.21948242 1876.82006836 2213.87915039 2592.18627930 3015.97241211 3490.40893555 4021.72851562 4615.8675778 5279.06 542969602 6 0.35156250 6851.67138672 7790.4980469 8855.44140625 10068.18847656 11434.60937500 12933.64550781 14548.29492188 16287.35351562 18161.21289062],
my MCI CTMLAYS is set to 1.000, 0.9979, 0.9956, 0.9931, 0.9904, 0.9875, 0.9844
0.9807, 0.9763, 0.9711, 0.9649, 0.400, 0.200, 0.000 ",
我发现了问题，我的点源高度是英尺，而我把他当成了米，所以我的SMOKE分层只有60米以前的数据是正确的。