Run smoke for EUG, and want to get multi-layer output

SMOKE
1

Hi ,
I am running SMOKE_v37 for EGU with stack height, I want to consider plume arise and get multi-layer output ,but got some “ERROR”. Let me show you details.
(1) When I set both “SMK_ELEV_METHOD” and “SMK_PING_METHOD” as “0”, it runs and got output files(but only one layer),the “ERROR” in “elevpoint” log-file was shown in Fig.1.

image
image790×289 8.42 KB

(2) However, if I set “SMK_ELEV_METHOD” as “1”, it runs and got output files(but only one layer),the “ERROR” in “elevpoint” log-file was shown in Fig.2.
image
image1024×271 9.08 KB

(3) If I set “SMK_PING_METHOD” as “1” , it runs and can not got any output-file, the “ERROR” in “elevpoint” log-file was shown in Fig.3.
image
image999×318 10.6 KB

Could you please tell me where to check.
I wil appreciate your suggestions and advices.

2

Could you please share your entire elevpoint log?

The version is unlikely to be the cause of your but I also recommend upgrading to a more recent SMOKE release if possible.